ADTRAN TA 5000 User Manual

Total Access 5000 Business Services Deployment Guide
6-6 65K510DEP08-1A
Create an EFM Bonding Group
Thissectiondetailsthefollowinginformation:
• DefinitionofanEFMbondinggroup
•StepsforconfiguringtheEFMbondingmanagement
•Stepsformodifyinganexistingbridge
•Auto‐ProvisiontheDS3pairsusingEZ‐EFM
•EFMbondingoverheaddescription
Bonding Group Definition
Abonding(bridge)groupisdefinedas“VirtualLANterminologyforagroupofswitchinter‐
facesassignedtoasingularbridgeunitandnetworkinterface.”
TheEFMbonding(bridge)groupbundlesmultipleDS3linestogethertoprovidebandwidth
equaltothesumoftheDS3sbonded.Thisprocessprovidesthe
necessarybandwidthfor
service.Forexample,threeDS3sbondedtogetherprovidethreetimesthespeedof1DS3
(3x44.736=134.208Mbpsofbandwidth)totransportethernettraffic.
Provisioning Steps
ThisprocedurecreatesanEFMbondinggroupattheGigESMthatbondsthephysicallayer
ports(DS3)oftheaccessmodule(s)together.
Tocreateanewbondinggroup,completethefollowing:
1. FromtheEnableprompt,type
application,andpressENTERtoaccesstheApplication
Configuratonprompt.
2. FromtheApplication Configurationprompt,type
ez-efm <shelf>,andpressENTERto
starttheEZEthernetapplication.
3. FromtheEFMConf igurationprompt,typeoneofthefollowingcommandstocreatean
EFMBondingGroup:
•ToprovisiontheDS3 EFM4‐Port,type
create WORD <EFM links> <slot/port>
upstream <0-250000> downstream <0-250000> active-links-minimum
<1-n>
, andpressENTER.
•ToprovisiontheDS3EFM3‐Port,type
create WORD <EFM links> <slot/
port:channel> upstream <0-250000> downstream <0-250000> active-
links-minimum <1-n>
, andpressENTER.

ADTRAN TA 5000 Specifications

General

Brand	ADTRAN
Model	TA 5000
Category	Network Router
Language	English