Total Access 5000 Business Services Deployment Guide
A-2 65K510DEP08-1A
Link Aggregation Provisioning
Toprovisionforlinkaggregation,completethefollowingprocedure:
Toaddcrossconnectstotheaggregationbridge,reprovisioningisrequired.
1. DisableLACP.
LACPmessagesmustbetemporarilydisabledwhilesettingupthelinkaggregation
group.Formoreinformation,referto“DisableLACP”onpage A‐2.
2. Ifneeded,enableadditionalGigabit‐Ethernetinterfaces.
Formoreinformation,referto“EnableNetworkInterfaces”onpage A
‐3.
3. CreateaLinkAggregation groupandaddGigabit‐Ethernetphysicalinterfaces.
Formoreinformation,referto“CreateaLinkAggregationGroup”onpage A‐3.
4. EnableLACP.
Formoreinformation,referto“EnableLACP”onpage A‐3.
5. Configurethedefaultnetworkinterfacetothenewlycreatedlinkaggregationgroup .
Formoreinformation,refer
to“ConfigureDefaultNetworkInterface”onpage A‐4.
6. CreateanEVCandlinkittothelinkaggregationgroup.
Formoreinformation,referto“ConfigureEVCs”onpage A‐4.
7. RedirectanycreatedEVCstoalinkaggregationgroup.
Formoreinformation,referto“RedirectEVCs”onpage A‐5.
Disable LACP
TodisableLACPforallactivegigabit‐ethernetports,completethefollowingprocedure:
1. FromtheEnableprompt,type
configure terminal,andpressENTERtoaccesstheGlo‐
balConfigurationprompt.
2. FromtheGigabitEthernetInterfaceConfigurationprompt,type
interface gigabit-
ethernet 1/A/1
,andpressENTERtoaccesstheGigabitEthernetInterfaceConfiguration
prompt.
3. FromtheGigabitEthernetInterfaceConfigurationprompt,type
no lacp mode,and
press
ENTERtodisableLACPforthegigabit‐ethernetinterface.
4. Repeatsteps2to3todisableLACPforallactivegigabit‐ethernetinterfaces
5. FromtheGigabitEthernetInterfaceConfigurationprompt,type
end,andpressENTERto
returntotheEnableprompt.
To Next Page
Loading...
Need help?
General
