ADTRAN TA 5000 User Manual

Section 3, Common Provisioning - Provision the GigE SM
65K510DEP08-1A 3-11
Provision the LACP Switchover Mode
AdifferenceinthewaythatCiscoandJu niperswitcheshandleLACPmessagingrequiresa
provisioningoption,calledlacpgrammarstandby‐aggregation.Tosetthisoption,complete
thefollowing:
1. FromtheEnableprompt,type
configure terminal,andpressENTERtoaccesstheGlo‐
balConfigurationprompt.
2. FromtheGlobalConfigurationprompt,type
interface gigabit-ethernet 1/A/1,
andpress
ENTERtoaccesstheGigabit‐EthernetpromptfortheactiveSM,networkport1.
NOTE
IfslotBistheactiveSM,use1/B/1forthe<shelf/slot/port>designator.
3. Dependingontheswitch,performoneofthefollowing:
•IftheTotalAccess5000isconnectedtoaCiscoswitch,type
no lacp grammar
standby-aggregation
,andpressENTER.
NOTE
Thenoversionofthelacpgrammarcommandisthedefaultvalue.
•IftheTotalAccess5000isconnectedtoaJuniperswitch,type
lacp grammar
standby-aggregation
,andpressENTER.
4. Type
end,andpressENTERtoreturntotheEnableprompt.

ADTRAN TA 5000 Specifications

General

Brand	ADTRAN
Model	TA 5000
Category	Network Router
Language	English