Section 7, EoF Provisioning - Create an EVC Map
65K510DEP08-1A 7-13
Provisioning Steps
Tocreatethemap,completethefollowingprocedure:
1. FromtheEnableprompt,type
configure terminal,andpressENTERtoaccesstheGlo‐
balConfigurationprompt.
2. FromtheGlobalConfigurationprompt,type
evc-map WORD,andpressENTERtocreate
themapandenterthemapconfigurationmode.
Thisattributeisanarbitrarystringthatisusedtoidentifythemap.Thevaluemustbe
uniqueacrossallmapsdefinedintheproductandisintendedformanagementand
controlpurposes.Thevalueisnotcarriedinanyfield
intheEthernet frame.
Configure the Map
TheUsertoNetworkInterface(UNI)andtheEVCmustbeconfiguredforthemap.Amap
bindstheUNItraffictotheEVC.Toconfigurethemap,completethefollowingprocedure:
1. FromtheEVC‐MapInterfaceConfigurationprompt,settheUNIbytyping
connectuni
gigabit-ethernet
followedbytheethernetportnumberin1/0/portformat,and
press
ENTER.
FortheNetVanta,theshelfisalways1andtheslotisalwayszero.
2. FromtheEVC‐MapConfigurationprompt,connectthenewmaptotheEVCbytyping
connect evc WORD,andpressENTER.
ThisattributeisthenameoftheEVCassociatedwiththemapandmustbespecified.
3. FromtheEVC‐MapConfigurationprompt,enablethemapbytyping
no shutdown,and
press
ENTER.
4. FromtheEVC‐MapConfigurationprompt,type
end,andpressENTERtoreturntothe
Enableprompt.
5. Tosavethechangestonon‐volatilememory,type
copy running-config startup-
config
,andpressENTER.
6. FromtheEnableprompt,viewthenewmapbytypingshow evc-map WORD,andpress
ENTER.
ThiscommandalsodisplaystheEVCandUNIthatthemapisattachedto.
Oncethisprocessiscompleted,datacanberunthroughthesystem.
Map Example
Thefollowingisasampleoutputoftheshowinterfacesmapcommandformap‐1200.
MyNV8044show evc-map map100
EVC-map map100
Admin State : Enabled
EVC-map Status : Running
Connected EVC : evc1100 (1200)