Allen-Bradley E300 - Page 197

Rockwell Automation Publication 193-UM015E-EN-P - October 2015 197
Operating Modes Chapter 5
Figure 102 - Non-reversing Starter (Network & Local I/O) with Feedback – Two-wire Control
Wiring Diagram
DeviceLogix Program
The DeviceLogix program that is shown in Figure 103 is automatically loaded
and enabled in the E300 on power-up or when Operating Mode (Parameter 195)
is set to a value of 17.
R03 R04
Relay 0
Run
E300
Control Power
IN 0
Run/Aux
IN 3
Local Inputs/
Controller
IN 2
Run/Stop