Allen-Bradley E300 - Device Configuration Policy; Device Reset Policy

Rockwell Automation Publication 193-UM015E-EN-P - October 2015 89
System Operation and Configuration Chapter 4
you can only modify the security policy when the E300 relay is in Administration
Mode (see page 77
to learn how to enable Administration Mode).
Table 45 - Security Policy (Parameter 211) Bit Function Detail
Device Configuration Policy
The Device Configuration Policy allows you to send external message
instructions via a communication network to write values to configuration
parameters. When this policy is disabled, all external message instructions with
configuration data return a communication error when the E300 relay is in Ready
Mode or Run Mode.
Device Reset Policy
The Device Reset Policy allows you to send external message instruction via a
communication network to perform a soft device reset when the E300 relay is in
Ready Mode. When this policy is disabled, all external reset message instructions
return a communication error when the E300 relay is in Ready Mode or Run
Mode.
Bit
1514131211109876543210 Function
X Device Configuration Enable
X Device Reset Enable
X Firmware Update Enable
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
X Security Policy Config Enable