Allen-Bradley E300 - Invalid Configuration Cause; Mismatch Status

Rockwell Automation Publication 193-UM015E-EN-P - October 2015 505
Metering and Diagnostics Chapter 8
Table 453 - Invalid Configuration Parameter (Parameter 38)
Invalid Configuration Cause
Invalid Configuration Cause (Parameter 39) reports the reason for the
configuration trip in the E300 relay. See Chapter 4
for more information about a
configuration fault.
Table 454 - Invalid Configuration Cause (Parameter 39)
Mismatch Status
Mismatch Status (Parameter 40) reports the module that is causing a mismatch
trip or warning in the E300 relay. See Chapter 4
for more information on a
mismatch fault.
Default Value 0
Minimum Value 0
Maximum Value 9999
Parameter Type UINT
Size (Bytes) 2
Scaling Factor 1
Units
Default Value 0
Range
0 = No Error
1 = Value Over Maximum
2 = Value Under Minimum
3 = Illegal Value
4 = L3 Current Detected
5 = CopyCat Error
Parameter Type USINT
Size (Bytes) 1
Scaling Factor 1
Units