574 Rockwell Automation Publication 193-UM015E-EN-P - October 2015
Chapter 10 EtherNet/IP Communication
View and Configure
Parameters
The web server in the E300 relay EtherNet/IP Communication Module when
enabled is able to view and configure parameters for the E300 relay. You can use
the web interface to edit parameters for E300 relay if it is not being scanned by an
EtherNet/IP scanner.
Viewing Parameters
Follow the steps below to view parameters using the web interface of the E300
relay EtherNet/IP Communication Module.
1. Using a web browser, open the web page of the E300 relay EtherNet/IP
Communication Module by typing its IP address for the URL.
2. Navigate to the Parameters folder and select a parameter group. The
example below shows the information from the Current Monitoring
parameters.
3. To increase the update rate of the data being viewed, enter a faster update
time in the refresh rate box shown below:
To Next Page
Loading...
