Rockwell Automation Publication 193-UM015E-EN-P - October 2015 307
Operating Modes Chapter 5
Monitor (Custom)
The E300 relay’s Operating Mode Monitor (Custom) (Parameter 195 = 54)
allows you to use the E300 relay as a monitoring device. No configuration rules
apply in this operating mode if all motor protection features are disabled.
Rules
1. If any protection trip events are enabled (excluding Configuration, NVS,
and Hardware Fault trip), then set any of the Output Ptxx Assignments
(Parameters 202…204) to the appropriate value of Trip Relay, Control
Relay, Monitor Lx Trip Relay, or Monitor Lx Control Relay.
Wiring Diagram
Not Applicable
To Next Page
Loading...
