Rockwell Automation Publication 193-UM015E-EN-P - October 2015 221
Operating Modes Chapter 5
Figure 126 - Reversing Starter (Operator Station) with Feedback Wiring Diagram
DeviceLogix Program
The DeviceLogix program that is shown in Figure 127 through Figure 130 is
automatically loaded and enabled in the E300 on power-up or when Operating
Mode (Parameter 195) is set to a value of 30.
R13 R14
Relay 1
Run Reverse
E300
Control Power
I- Run Forward
0- Stop
II- Run Reverse
R03 R04
Relay 0
Run Forward
Run Forward Aux
IN 0
Run Reverse Aux
IN 1
To Next Page
Loading...
