Rockwell Automation Publication 193-UM015E-EN-P - October 2015 423
Protective Trip and Warning Functions Chapter 6
Over Power Factor Leading Trip Delay
Over Power Factor Leading Trip Delay (Parameter 423) allows you to define the
time period an over power factor leading condition must be present before a trip
occurs. It is adjustable from 0.1…25.0 seconds.
Table 362 - Over Power Factor Leading Trip Delay (Parameter 423)
Over Power Factor Leading Trip Level
Over Power Factor Leading Trip Level (Parameter 424) allows you to define the
total power factor leading at which the E300 relay trips on over power factor
leading. It is user-adjustable from 0…2,000,000 kW.
The Protection Fault State of Relay 0, Relay 1, Relay 2, Digital Module 1 Output
Relays, Digital Module 2 Output Relays, Digital Module 3 Output Relays, and
Digital Module 4 Output Relays are defined by the respective parameters:
• Output PT00 Protection Fault Action (Parameter 304)
• Output PT00 Protection Fault Value (Parameter 305)
• Output PT01 Protection Fault Action (Parameter 310)
• Output PT01 Protection Fault Value (Parameter 311)
• Output PT02 Protection Fault Action (Parameter 316)
• Output PT02 Protection Fault Value (Parameter 317)
• Output Digital Module 1 Protection Fault Action (Parameter 322)
• Output Digital Module 1 Protection Fault Value (Parameter 323)
• Output Digital Module 2 Protection Fault Action (Parameter 328)
• Output Digital Module 2 Protection Fault Value (Parameter 329)
• Output Digital Module 3 Protection Fault Action (Parameter 334)
• Output Digital Module 3 Protection Fault Value (Parameter 335)
• Output Digital Module 4 Protection Fault Action (Parameter 340)
• Output Digital Module 4 Protection Fault Value (Parameter 342)
Default Value 1.0
Minimum Value 0.1
Maximum Value 25.0
Parameter Type USINT
Size (Bytes) 1
Scaling Factor 10
Units Seconds
To Next Page
Loading...
Need help?
General
