588 Rockwell Automation Publication 193-UM015E-EN-P - October 2015
Chapter 10 EtherNet/IP Communication
If the upload is not successful due to communication errors, a display appears
indicating that there was an upload error; the device profile uses its existing
settings. Press OK to continue. Identify and fix the reason for the communication
error and press Upload again, or press Cancel to remove any module definition
changes.
If the upload is not successful due to an E300 configuration trip, a display appears
indicating that the profile is using its existing settings. Press OK to continue. Read
parameters 38 and 39 from the E300 relay to determine the reason for the
configuration trip. Fix the issue and press Upload again, or press Cancel to remove
any module definition changes.
ATTENTION: If an Upload command is not successful when manually adding an
E300 relay, failure to cancel the new module addition process results in the loss
of any preconfigured E300 relay configuration data. Default values are used
when the RSLogix 5000 or Studio 5000 project is downloaded to the Logix
controller or when adding an E300 relay online to a ControlLogix project.
To Next Page
Loading...
Need help?
General
