EasyManuals Logo

Allen-Bradley E300 User Manual

Allen-Bradley E300
736 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
Rockwell Automation Publication 193-UM015E-EN-P - October 2015 7
Table of Contents
Reversing Starter Operating Modes. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 205
Reversing Starter (Network) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 205
Reversing Starter (Network) with Feedback . . . . . . . . . . . . . . . . . . . 209
Reversing Starter (Operator Station) . . . . . . . . . . . . . . . . . . . . . . . . . . 214
Reversing Starter (Operator Station) with Feedback. . . . . . . . . . . . 219
Reversing Starter (Local I/O) – Two-wire Control. . . . . . . . . . . . . 226
Reversing Starter (Local I/O) – Two-wire Control
with Feedback. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 230
Reversing Starter (Local I/O) – Three-wire Control. . . . . . . . . . . . 235
Reversing Starter (Network & Operator Station) . . . . . . . . . . . . . . 239
Reversing Starter (Network & Local I/O) – Two-wire Control . 245
Reversing Starter (Network & Local I/O) – Three-wire Control 250
Reversing Starter (Custom) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 255
Two-speed Starter Operating Modes. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 256
Two-speed Starter (Network) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 257
Two-speed Starter (Network) with Feedback . . . . . . . . . . . . . . . . . . 261
Two-speed Starter (Operator Station). . . . . . . . . . . . . . . . . . . . . . . . . 266
Two-speed Starter (Operator Station) with Feedback . . . . . . . . . . 271
Two-speed Starter (Local I/O) – Two-wire Control. . . . . . . . . . . . 278
Two-speed Starter (Local I/O) –
Two-wire Control with Feedback. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 282
Two-speed Starter (Local I/O) – Three-wire Control . . . . . . . . . . 287
Two-speed Starter (Network & Operator Station) . . . . . . . . . . . . . 290
Two-speed Starter (Network & Local I/O) – Two-wire Control 296
Two-speed Starter (Network & Local I/O) –
Three-wire Control. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 301
Monitor Operating Mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 306
Monitor (Custom) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 307
Chapter 6
Protective Trip and Warning
Functions
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 309
Current-based Protection. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 309
Overload Protection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 312
Phase Loss Protection. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 319
Ground Fault Current Protection . . . . . . . . . . . . . . . . . . . . . . . . . . . . 321
Stall Protection. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 327
Jam Protection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 330
Underload Protection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 333
Current Imbalance Protection. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 336
Line Undercurrent Protection. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 340
Line Overcurrent Protection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 349
Line Loss Protection. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 357
Voltage-based Protection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 364
Undervoltage Protection. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 367
Overvoltage Protection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 370
Voltage Imbalance Protection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 373
Phase Rotation Protection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 376

Table of Contents

Other manuals for Allen-Bradley E300

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Allen-Bradley E300 and is the answer not in the manual?

Allen-Bradley E300 Specifications

General IconGeneral
TypeElectronic Overload Relay
MountingDIN Rail or Panel Mount
Protection ClassIP20
Voltage Range24…690 V AC/DC
Communication OptionsEtherNet/IP, DeviceNet
ProtectionOverload, phase loss, ground fault
Operating Temperature-20°C to 60°C

Related product manuals