AutomationDirect DL205 Manual

DL205 Analog Manual, 7th Edition Rev. D
16-4
Chapter 16: F2-8AD4DA-2, 8-Ch. In / 4-Ch. Out Analog Voltage Combination
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
C
D
NOTE: One count in the specifications table is equal to one least significant bit of analog data value (1 in
65536)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
C
D
Output Specifications
Number of Output Channels
4
Output Range
0–5V, 0–10V
Output Resolution
16 bit; 76μV / bit @ 0–5V; 152μV / bit @ 0–10V
Output Type
Voltage sourcing / sinking at 10mA max.
Output Signal at Power-up & Power-down
0V
Output Impedance
0.2q typical
External Load Resistance
>1000q
Maximum Capacitive Load
0.1 μF
Allowed Load Type
Grounded
Max. Continuous Output Overload
Limited to 15mA typical
Type of Output Protection
15VDC Peak Output Voltage
(clamped by transient voltage suppressor)
PLC Output All Channel Update Time
4ms (local base)
Output Settling Time
0.5 ms max.; 5 μs min. (full scale change)
Output Ripple
0.005% of full scale
Accuracy vs. Temperature
±25 ppm/ °C max. full scale calibration change (±0.0025%
of range / °C)
Output Stability and Repeatability
±1 LSB after 10 minute warm-up typical
Output Inaccuracy
0.1% of range maximum
Linearity Error (end to end)
±33 counts max. ( ±0.05% of full scale)
Monotonic with no missing codes
Full Scale Calibration Error
(not including offset error)
±0.07% of range maximum
Offset Calibration Error
±0.03% of range maximum
Crosstalk at DC, 50/60Hz
-70 dB or 0.025% of full scale

AutomationDirect DL205 Specifications

General

Brand	AutomationDirect
Model	DL205
Category	Controller
Language	English