Page 18 – 1. Quick Start
TitanUniversal_Man_v10_QU.doc 15 March 2016
1.5 DMX / network setup
The console can output up to 12 universes of DMX (called DMX Lines)
which may be routed to the 4 XLR sockets or over Ethernet. The Pro
versions of Pearl Expert and Tiger Touch can output 16 Universes.
The Titan One dongle is limited to a single universe. By connecting
further Titan Processing Nodes to the network using TitanNet, you
can control up to 64 universes.
Multiple consoles can be linked by Ethernet to provide a multi-user
system, or to provide tracking backup (Section 11.6,p223).
Swi
tch to System mode by holding Avo and pressing Disk, press
[DMX Settings].
Select a Node on the left (where the DMX is going to), click the blue
arrow. On the right, select the DMX line it will be fed by. The ‘i’
buttons set properties for Nodes/Lines. (Section 5.5, p249).
To change the IP address of the console, press [Network Settings] in
System mode (Section 15.1.1, p263).
To change User Setti
ngs which let you personalise how the console
works, hold down Avo and select [User Settings] (Section.13.1.3,
p233).
To Next Page
Loading...
