4. Controlling dimmers and fixtures - Page 73
TitanUniversal_Man_v10_QU.doc 15 March 2016
Attribute Options (just above Locate), then press
Pan/Tilt (or Position), then release Locate.
Changing the locate state
You can permanently change the locate state of each fixture by
recording a new Locate State. This can be shared (applies to all
fixtures of the same type) or individual. To store, set up the desired
locate state, then press Record, then Locate. Select [Shared] or
[Individual] from the softkeys. Press Record or Locate a second time
to confirm.
4.1.3 Clearing selection
The Clear button (on the right of the numeric keypad) is used to
remove all changes from the Programmer and deselect all fixtures. A
quick press of the Clear button just clears everything, however if you
hold down the Clear button, then more options are available.
• You can mask which attributes are to be cleared (for example,
leaving the pan/tilt in the programmer but clearing everything
else) by holding down Clear and pressing [Set Mask to Clear
Nothing]. Then (still holding Clear) turn on the Attributes you
want to change using the Attribute Bank buttons down the right
hand side, or press [Set Mask] and use the softkeys. Only the
lit attributes will be cleared. Pressing the Attribute Options
button will clear the mask. The Time mask option allows you to
clear or retain the fade/delay times in the programmer for all
attributes (clearing individual attributes will also clear times for
that attribute, for example setting a P mask will clear position
times).
• [Clear Options] opens a submenu showing some further options
(described below).
• [Clear All Fixtures/Selected Fixtures] sets whether all fixtures
will be cleared from the programmer, or if only currently
selected fixtures will be cleared. This is useful if you want to
clear specific fixtures.
• [Individual Attributes] allows you to clear individual attributes
from the Programmer. When you press the softkey, you are
given a list of attributes in the Programmer – press the
appropriate softkey to clear that attribute.
• [Clear All Programmers] will clear all programmers that are
currently active on the console. This will be used for multi-user
programming in future and is currently used to clear values
added to the Titan Remote programmer.
The options in the “Clear Options” submenu are:
• [Auto Reset Mask] sets the mask to be automatically reset to
clear everything each time Clear is pressed, or you can toggle
the option to [Remember Mask] which will keep the mask
setting you used last time.
• [Leave/Zero Preset Fader Levels] is used to set whether latched
fixtures are cleared (the fixture key profile can be set to “Latch”
mode, which turns on the fixture dimmer channel when the
fixture button is touched. See section
13.4.1 on page 242.)
To Next Page
Loading...
