Page 256 – 13. User Settings and other options
TitanUniversal_Man_v10_QU.doc 15 March 2016
13.9 Recovering/reinstalling the system
The console runs on an embedded PC system, and like all computers,
there is a possibility of system failure. The console software can be
reloaded using the recovery USB stick (or CD, if a drive is fitted)
provided with the console, or you can download a recovery disk
creator application from the Avolites download website which will
automatically create a recovery stick.
Some consoles may require you to change the BIOS settings to allow
them to boot from the USB recovery stick. If the console does not
boot into the recovery application, use the procedure below. You will
need to have a USB keyboard attached if the console does not have
one fitted as standard.
13.9.1 Booting from USB recovery stick
1> Ensure memory stick is plugged in.
2> Start up console pressing Delete button to enter the BIOS.
3> When prompted, type in the password '68340', to enter the
BIOS.
4> Once in the BIOS, press down arrow once then Enter button to
open the second menu.
5> Then again, press down arrow once then Enter button to open
the second menu.
6> Press the PgDn button repeatedly until 'USB-HDD0' is in
position 1.
7> Press F10 then Enter, to save changes.
8> When the console starts it will boot automatically into the
memory stick.
After you have installed the software, go back into the BIOS and
change boot back to the internal hard disk.
Using the recovery stick will delete all settings and files
from the console including show files and user
personalities. Any files should be saved to a USB stick
before continuing.
13.9.2 Installation Instructions
1> Wait while the memory stick boots up, this can take up to 3
minutes.
2> Once the memory stick has booted, the touch screen will
display 'Welcome to (Console Name)', touch Next to continue.
3> Please read to the bottom of the licence agreement then touch
Agree to accept.
4> On the next screen type in the serial number of the console
(using the numeric keypad) - this is the number written on the
back of the console.
5> Touching Install will then format the hard drive and copy the
setup files to it.
6> Once complete unplug the memory stick and touch the Restart
button.
To Next Page
Loading...
