4. Controlling dimmers and fixtures - Page 85
TitanUniversal_Man_v10_QU.doc 15 March 2016
4> Touch the select button of the fixture or group you want to copy
the settings from.
The fixture selection order is used to determine how the aligned
values are copied.
• The [Auto Reset Mask] option will always set the mask to
Include All whenever you enter the Align Fixtures function. The
alternative option [Remember Mask] will leave the last mask
set.
• [Spread Attributes] will try to spread out the attribute changes
if there are a different number of fixtures in the source and
target groups (best for positions). [Repeat Attributes] will
repeat the source selection on extra fixtures, or attempt to
mirror the fixtures if there are fewer.
• [Align Programmer Attributes] will only align attributes which
are in the programmer, [Align All Attributes] will do everything.
• [Palette References Maintained] will copy palettes from the
source fixtures. [Palette References Lost] will convert the
palettes to absolute values in the target fixtures.
4.1.18 Flip
Moving head fixtures can point at the same stage position from two
possible yoke positions. Sometimes to get the fixture moving the
same as other fixtures, you need to swap to the opposite yoke
position and the Flip function lets you do that.
1> Select the fixtures you want to Flip.
2> At the top level menu press Menu Latch then C [Flip Pan and
Tilt].
The settings used for Flip are defined in the fixture
personality. If Flip doesn’t work you may need to update
to the latest personality.
4.1.19 Fan mode
Fan mode automatically spreads out the values on a selected range of
fixtures. If used on pan and tilt, the result is spreading out “rays” of
light beams. The first and last fixtures of the range are affected most,
and the central fixtures are affected least. The amount of fan can be
set using the attribute wheels.
As with shapes, the order in which you select the fixtures sets how
the fan effect works. The fixtures you select first and last will be the
ones which change most. If you use a group to select the fixtures,
the order you selected the fixtures when you recorded the group is
used.
The fan effect, while normally used on pan or tilt attributes, can be
applied to any attribute.
1> Select the fixtures you want to fan.
2> Press the Fan button.
To Next Page
Loading...
