Page 84 – 4. Controlling dimmers and fixtures
TitanUniversal_Man_v10_QU.doc 15 March 2016
3> The ALL button will select all fixtures in the programmer
(everything which has been selected since Clear was last
pressed).
• The Hilight function can be used to highlight the output of the
selected fixture (make it brighter onstage), see the next
section.
4.1.14 Highlighting the selected fixture with Prev/Next
When stepping through a fixture selection using the Prev/Next/All
buttons, you can highlight the selected fixture on stage. This makes it
very easy to see which fixture you are controlling. The other fixtures
in the selection go to a dimmed “lowlight” level.
• Press the HiLight button to enable highlight mode. Press HiLight
again to disable. When you are in highlight mode, the
highlighted attribute is overridden and any changes you make
to it are not stored in the programmer (so if the highlight uses
intensity, you cannot change the intensity of the fixture).
• You can change the levels used for Highlight/Lowlight by then
pressing HiLight, [Store Highlight State] or [Store Lowlight
State].
4.1.15 Flash selected fixtures to full
It can be useful when programming to see on stage which fixtures
you have got selected. Press the Flash Full button to do this (Avo +
Page+1 button). You may also want to turn off selected fixtures, the
Flash Out button does this.
4.1.16 Turn off unselected fixtures
To turn off all unselected fixtures use the Remainder Dim function by
pressing Rem Dim (Avo+All). The zero intensity is placed in the
programmer and will be recorded into any cue. This is useful when
removing fixtures from cues.
4.1.17 Align fixtures
You can copy attributes from one fixture to another using the Align
Fixtures function. This is very useful, for example, if you’ve
accidentally left a fixture out of a cue you can copy settings from its
neighbour.
You can align multiple fixtures to others in one operation, either using
groups or individual selection. If you are aligning different numbers of
fixtures there are options to set how this is handled, see below.
1> Select the fixtures you want to Align either manually or using a
group.
2> At the top level menu press Fixture Tools/ML Menu then [Align
Fixtures].
3> Set the mask to include the attribute groups you want to copy
(using the Attribute Bank buttons, or using the softkey options
for exclude and include all attributes).
To Next Page
Loading...
