12. Remote control - Page 229
TitanUniversal_Man_v10_QU.doc 15 March 2016
12.2 Operating the remote
To connect to the console, open the Titan Remote app and a list of
available consoles will be shown - hopefully if you have done the
network setup correctly, you will see your console listed.
There is also a local emulator which can be used to test or
demonstrate the remote when no real console is connected.
Choose what you want to control using the row of buttons across the
middle of the app. The Keypad button enables or disables the numeric
pad (the keypad overlays all the other screens, so you will need to
turn it off to see the others).
12.2.1 Keypad
The keypad screen lets you do most common tasks in the way a
programmer's remote normally works. You can turn on/Locate
fixtures and dimmers either singly or together.
The User Number of the fixture or dimmer is used for control. For
example to turn on dimmer 3 at 50% you would press:
3@5
To turn on dimmers 1-10 at 80% you would press:
1 Thro 10 @ 8
For 100% you just press @ twice, for example
1 Thro 10 @ @
To Next Page
