Page 200 – 9. Cue Lists
TitanUniversal_Man_v10_QU.doc 15 March 2016
9.6 Cue list options
Cue list options are set from the Playback Options menu. You can
enter the playback options menu by doing the following
1> At the top level menu press [Playback Options].
2> Press the select button for the cue list you wish to edit.
You can show the cue list options in a window by pressing Window
Open then the Select button of the cue list, then click the Options
tab.
The Cue List options are mostly the same as for Cues and Chases,
only the additional Cue List options are described here.
9.6.1 Cue List options - Playback
Blind, Priority, Shape Behaviour are described in the Cues chapter on
page 167.
Tracking: Enabl
es or disables Tracking mode (where unchanged
settings persist from the previous cues)
Shape Tracking: Sets how shapes are tracked between cues.
Off – Shapes will stop when the next cue starts
On – Shapes will track until stopped or changed in a cue
Local – Follows the tracking option above
Move In Dark: Sets the mode for the whole cue list (see section
Tracking
By
default, cue lists run in tracking mode. Only changes in attributes
are stored, everything else just continues at the level it was
previously set to. Tracking mode is usually used for theatrical
performances because it means that if you need to adjust a dimmer
level at the start of a scene, you don’t have to go through and change
the level on every cue for that scene, the change just tracks through
the other cues until a new level is stored.
You can enable or disable Tracking mode globally for the whole cue
list, or each cue can have Tracking mode set individually from the
Playback View window (or Playback Options, [Cue Options]).
Settings are:
To Next Page
