Baumuller b maXX BM5800 - Page 175

Description of the Software Modules and Parameters
Parameter manual b maXX BM5800
Document No.: 5.16029.03
175
of 814
3
137.20 Type name
Model name of the encoder.
The following strings are displayed for encoder without communication (without serial
data interface):
m Resolver „Resolver“
m Square-wave incremental encoder (5 V; TTL): „Incremental encoder“
m Sine incremental encoder (~1 Vpp): „Sine incr. encoder“
Encoder with communication:
m Sine-Cosine encoder with SSI interface: "SSI encoder"
m Sine-Cosine encoder with HIPERFACE

:
The identification is displayed depending on the read type identification:
e.g.: SRM 60 with identification 27
hex
: „SRM 50/60 / SCM-Kit 101“ 
SKS 36 with identification 32
hex
: „SKS 36“
unknown identification: „unknown“
m Sine-Cosine encoder with EnDat

The specified name is composed as follows:
Type of encoder + designation of order + EnDat version + EnDat instruction set
e.g.: Multiturn encoder EQN1325
designation of order 01; EnDat version 02; instruction set 2.2;
Z137.20– = „MultiRotaryED01-2.2“
Singleturn encoder ECN1313
designation of order is not in electronic type plate; EnDat version 02; 
instruction set 2.1;
Z137.20– = „SingleRotaryEDxx-2.1“
137.21 Serial number
Serial number of the encoder.
137.22 Firmware version
Firmware version of the encoder.
The version of the EnDat

interface is displayed at EnDat

encoder. Only the incompat-
ible part of the version will be displayed. The compatible part (to the right of the decimal
point) is missing.
137.23 Firmware date
Date of the encoder firmware version.