Baumuller b maXX BM5800 - Page 196

Configuration
Parameter manual b maXX BM5800
Document No.: 5.16029.03 Baumüller Nürnberg GmbH
196
of 814
3.4
52.4 Mean Isq 1
Display of the determined torque-producing currents while the drive is being operated at
constant speed Speed_1.
52.5 Mean Isq 2
Display of the determined torque-producing currents while the drive is being operated at
constant speed Speed_2.
52.6 Ks result acceleration
Display of the Ks results determined during an acceleration procedure. Interim result to
evaluate the parameter
Z52.8–.
52.7 Ks result deceleration
Display of the Ks results determined during a braking procedure. Interim result to evaluate
the parameter
Z52.8–.
52.8 Ks measured
Display of the Ks value determined.
If Ks was evaluated by the accelerating/braking method the value is shown in >52.8<
from the parameters
Z52.6– and Z52.7– by averaging. Both values should not differ too
much (+/-10%). A negative value means that the measurement was not successful.
52.9 Load friction factor
The determined coefficient of sliding friction, b, is displayed here in units of [(A/degree)/s].
52.10 Load friction
The determined static friction coefficient c is displayed here in units of [A].