Baumuller b maXX BM5800 - Page 585

Description of the Software Modules and Parameters
Parameter manual b maXX BM5800
Document No.: 5.16029.03
585
of 814
3
Remark:
m Bit 5:
The bit shows whether the entire tipping speed at the input was set to zero.
Total tipping speed = Jogging speed (Z119.3–) * Feed rate override (Z121.7–)
119.2 Mode
119.3 Jogging speed
The tipping speed indicates the adjustment speed of the drive in manual drive operation.
The total tipping speed to be reached results from 
Tipping speed * Feed rate override (Z121.7–).
119.4 Jogging acceleration
The jogging acceleration describes the maximum permitted acceleration of the drive in
manual drive operation.
119.5 Jogging deceleration
The jogging deceleration describes the maximum permitted deceleration of the drive in
manual drive operation.
14 1: Drive into negative direction was prevented by limit switch
15 1: Drive into positive direction was prevented by limit switch
31 … 16 Reserved
Bit Meaning
Bit Meaning
0 1: Synchronization to speed actual value with activation of manual drive
operation
1 Speed profile
0: Trapezoidal profile
1: S-Curve
15 … 2 Reserved