Baumuller b maXX BM5800 - Page 656

Operating Modes
Parameter manual b maXX BM5800
Document No.: 5.16029.03 Baumüller Nürnberg GmbH
656
of 814
3.8
The delay of the smoothed master axis position due to the PT
1
is automatically compen-
sated compared to the original position.
After acceleration procedures the compensation causes an increase of the master axis
speed compared with the original master axis speed with the compensation time. The fol
-
lowing axis drive must be able to move continuously by an increased speed. It can be re-
duced by lower acceleration values when starting up.
The compensation time is dependent of the size of the time constant (low time constant
 low smoothing effect  quick compensation).
122.30 Flex. segment no.1
Segment number for the first flexible segment where the traversing distances were
changed during movement.
122.31 Flex. master distance revolutions 1
The revolution portion of the changed master axis travel for the segment with the number
from
Z122.30–.
122.32 Flex. master distance angle 1
The angular portion of the changed master axis travel for the segment with the number
from
Z122.30–.
122.33 Flex. slave distance revolutions 1
The revolution portion of the changed drive system travel for the segment with the number
from
Z122.30–.
122.34 Flex. slave distance angle 1
The angular portion of the changed drive system travel for the segment with the number
from
Z122.30–.
122.35 Flex. segment no.2
Segment number for the second flexible segment where the traversing distances were
changed during movement.