Description of the Software Modules and Parameters
Parameter manual b maXX BM5800
Document No.: 5.16029.03
657
of 814
3
122.36 Flex. master distance revolutions 2
The revolution portion of the changed master axis travel for the segment with the number
from
Z122.35–.
122.37 Flex. master distance angle 2
The angular portion of the changed master axis travel for the segment with the number
from
Z122.35–.
122.38 Flex. slave distance revolutions 2
The revolution portion of the changed drive system travel for the segment with the number
from
Z122.35–.
122.39 Flex. slave distance angle 2
The angular portion of the changed drive system travel for the segment with the number
from
Z122.35–.
122.41 Sequence change at the end
With this parameter which is cyclical writable a coupling / decoupling point of the se-
quence change is specified. This parameter must be considered in combination with
Z122.6–.
The parameter is two-parted:
The sequence change is specified here. The change is processed by a rising edge of bit 5
of
Z108.1– "Control word".
122.42 Numerator gear factor
Numerator of the gear factor at the output of the polynomial curve generator.
Sequence change >122.6<
16 bit accessed segment 16 bit following segment
To Next Page
Loading...