Biotek MultiFlo FX - Page 309

System Error Codes | 287
Code Message What to do
C01 Configuration or autocal data
missing
Service Only.
Contact BioTek TAC.
C02 Checksum mismatch -calculated
checksum didn’t match saved
checksum
Service Only.
Contact BioTek TAC.
C03 Configuration parameter out of
range
Service Only.
Contact BioTek TAC.
1001 Bootcode powerup checksum
test failed
Contact BioTek TAC.
1002 Unknown error in bootcode Contact BioTek TAC.
1003 Bootcode page program error Contact BioTek TAC.
1004 Bootcode block size error (not
256)
Contact BioTek TAC.
1005 Invalid processor signature (not
1280,1281,2560,2561)
Contact BioTek TAC.
1006 Bootcode memory exceeded Contact BioTek TAC.
1007 Invalid slave port Contact BioTek TAC.
1008 Invalid response from slave Contact BioTek TAC.
1009 Invalid processor detected Contact BioTek TAC.
1010 Checksum error downloading
basecode
Contact BioTek TAC.
1250 Internal RAM test error on the
UI processor
Contact BioTek TAC.
1251 Internal RAM test error on the
MC processor
Contact BioTek TAC.
1260 Stack test error on the UI Contact BioTek TAC.
1261 Stack test error on the MC Contact BioTek TAC.
1300 Invalid syringe selection Contact BioTek TAC.
BioTek Instruments, Inc.