Biotek MultiFlo FX - Page 320

298 | Appendix A: Error Codes
Error
Code
Description Help
6064 The protocol specifies more Peri-
pumps than are available.
The protocol may have been created for a
different instrument. Make sure the
instrument settings match the current
instrument and modify the protocol.
6065 Too few data bytes received from the
instrument.
Contact BioTek TAC.
6067 The type of Syringe pump is not
compatible with the syringe manifold.
Contact BioTek TAC.
6070 Invalid Syringe specified. Service Only.
Contact BioTek TAC.
These codes indicate an unexpected
software error that cannot be fixed
without BioTek support.
6071 Invalid number of syringe prime
cycles.
6072 Invalid syringe Aspirate Delay value.
6073 Invalid X-axis offset value.
6074 Invalid Y-axis offset value Service Only.
Contact BioTek TAC.
These codes indicate an unexpected
software error that cannot be fixed
without BioTek support.
6075 Invalid Z-axis offset value
6080 Invalid Peri-pump prime duration Service Only.
Contact BioTek TAC.
These codes indicate an unexpected
software error that cannot be fixed
without BioTek support.
6085 Invalid minutes:seconds value
6086 Invalid hours:minutes value
6087 'Move carrier home' is required when
duration exceeds 1 minute.
Contact BioTek TAC
MultiFlo™ FX Multi-Mode Dispenser