Brother HL-S7000DN - Resetting Printer to Default Settings

2-115
Confidential
■ Paper jam at the eject system
<User Check>
- Check if the paper is loaded into each paper tray correctly.
- Turn back the paper loaded in each paper tray or change the orientation of the paper by 180°.
- Adjust each paper guide corresponding to the paper size.
- Check if too much paper is loaded in the tray.
- Check if the thickness of the paper is 60 to 105 g/m
2
.
- Fan the stack of paper well and reinsert the papers into each paper tray.
■ Paper jam at the optional eject system
<User Check>
- Check if the paper is loaded into each paper tray correctly.
- Turn back the paper loaded in each paper tray or change the orientation of the paper by 180°.
- Adjust each paper guide corresponding to the paper size.
- Check if too much paper is loaded in the tray.
- Check if the thickness of the paper is 60 to 105 g/m
2
.
- Fan the stack of paper well and reinsert the papers into each paper tray.
Step Cause Remedy
1 Foreign object in the eject
system
Remove the foreign object.
2 Coming off of eject actuator Re-assemble the eject actuator.
3 Paper eject installation failure Re-assemble the paper eject ASSY.
4 Paper eject sensor PCB harness
connection failure
Reconnect the paper eject sensor PCB
harness.
5 Paper eject sensor failure Replace the paper eject ASSY.
6 Main PCB failure Replace the main PCB ASSY.
Step Cause Remedy
1 Foreign object in the optional
eject system
Remove the foreign object.
2 Coming off of optional output
actuator
Re-assemble the optional output actuator.
3 Harness connection failure of
eject solenoid
Reconnect harness of eject solenoid.
4 Optional output unit installation
failure
Re-assemble the optional output unit.
5 Optional output tray eject sensor
PCB harness connection failure
Reconnect the optional output tray eject
sensor PCB harness.
6 Optional output sensor failure Replace the optional output unit.
7 Main PCB failure Replace the main PCB ASSY.