3-83
Confidential
(16) Remove the Supply pump ASSY and Sub tank ASSY from the Main frame.
Fig. 3-88
Note:
Be careful that the Head joint section will not come into contact with Main frame.
Assembling Note:
- To replace the Supply pump ASSY and Sub tank ASSY, when removing the Tubes of the
Supply tube for tank B, Humid tube BK GO B, Humid tube FG GO B, Humid tube BK RTN
A, Humid tube FG RTN A, Sub tank tube FG A, and Sub tank tube BK A, they can be
reused only once by cutting the top end of the Tubes. When cutting a Tube, be sure to
use scissors without oil and dirt attached and vertically cut the top end of the Tube by 5
mm. If the Tube has already been cut, be sure to replace it with a new one.
- When tightening the Ink head attachment with screws, tighten the screws lightly using a
precision screwdriver. (The tightening torque is 1.5±0.2 kg/cm.)
Supply pump ASSY
Sub tank ASSY
Main frame
Head joint section
To Next Page
Loading...
