Security Traffic
Performance
BandwidthPerformanceMemoryEmbedded Services
Processor
40 Gbps200 Gbps
•
Quad
Quantum
Flow packet
processor
complex:
◦
2 GB
total
packet
buffer
◦
8 GB
total
resource
memory
•
Dual 80MB
TCAM4
feature lookup
memory
•
32GB of
1066MHz
DDR3
SDRAM:
◦
Four
8GB,
2-rank
registered
DIMMs
Cisco
ASR1000-ESP200
1
While both the Cisco ASR1000-ESP40 and ASR1000-ESP20 exceed the 16 Mpps forwarding rate, the ESP40 packets per second rate is slightly less than
ESP20 when sending continuous stream of small, 64-byte packets. However, at 92 bytes and larger, the ASR1000-ESP40 outperforms ESP20. The difference
at small packet sizes is a side-effect of optimizations made to achieve 40 Gbps for medium to large packets.
For unsupported hardware component configuration combinations, see xref Table 2-4.Note
The embedded services processor consists of a front panel label for indicator and control functions. The Cisco
ASR 1000 Series Embedded Services Processor model number labeling is located next to the left card module
handle. The module also contains card handles to assist in insertion or removal of the module. There are no
front panel interfaces on the Cisco ASR1000-ESP modules.
The following figure displays the Cisco ASR 1000 Series Embedded Services Processor LEDS on the front
panel.
Cisco ASR 1000 Series Router Hardware Installation Guide
97
Cisco ASR 1000 Series Routers Embedded Services Processors
Features of the Cisco ASR 1000 Series Embedded Services Processors
To Next Page
Loading...
Need help?
General
