DescriptionSetting
Check this check box to indicate the first redirecting number and
the redirecting reason of the call when the call is forwarded. (The
UUIE part of the outgoing SETUP message from the Cisco Business
Edition 3000 includes the Redirecting Number IE.)
Uncheck the check box to exclude the first redirecting number and
the redirecting reason.
You use Redirecting Number IE for voice-messaging integration
only. If your configured voice-messaging system supports
Redirecting Number IE, check the check box.
Redirecting Number IE
Delivery–Inbound
Check this check box to accept the Redirecting Number IE in the
incoming SETUP message to the Cisco Business Edition 3000. (The
UUIE part of the SETUP message includes the Redirecting Number
IE.)
Uncheck the check box to exclude the Redirecting Number IE.
You use Redirecting Number IE for voice-messaging integration
only. If your configured voice-messaging system supports
Redirecting Number IE, you should check the check box.
Redirecting Number IE
Delivery–Outbound
Check this check box only if users are not receiving ringback tones
on outbound calls.
When this check box is checked, the Cisco Business Edition 3000
sends Q.931 Setup messages out digital (that is, non-H.323)
gateways with the Progress Indicator field set to non-ISDN.
This message notifies the destination device that the gateway is
non-ISDN and that the destination device should play in-band
ringback.
This problem usually associates with a Cisco Business Edition 3000
that connect to PBXs through digital gateways.
Setup non-ISDN Progress Indicator IE
Enable
Check the check box to send the calling name in the Facility IE
field. By default, the Cisco Business Edition 3000 leaves the check
box unchecked.
Set this feature for a private network that has a PRI interface that
is enabled for ISDN calling name delivery. When this check box is
checked, the calling party name gets sent in the Facility IE of the
SETUP or FACILITY message, so the name can display on the
called party device.
Set this feature for PRI trunks in a private network only. Do not set
this feature for PRI trunks that are connected to the PSTN.
This field applies to the NI2 protocol
only.
Note
Send Calling Name In Facility IE
Outbound Call Routing
Administration Guide for Cisco Business Edition 3000, Release 8.6(4)
274 OL-27022-01
Connection Settings