D-Link xStack - Page 1019

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1014
DGS-3620-28SC:admin#show ripng
Command: show ripng
Global State: Disabled
Method: Split Horizon
Update Time: 30 seconds
Expire Time: 180 seconds
Garbage Collection Time: 120 seconds
Interface State Metric
-----------------------------------------------------
Total Entries : 0
DGS-3620-28SC:admin#
88-4 config ripng
Description
This command is used to configure the RIPng algorithm and timer.
Format
config ripng {method [no_horizon | split_horizon | poison_reverse] | update <sec 5-65535> |
expire <sec 1-65535> | garbage_collection <sec 1-65535>} (1)
Parameters
method - (Optional) Specifies the method used.
no_horizon - Specifies to configure not use any horizon.
split_horizon - Specifies to configure use a basic split horizon.
poison_reverse - Specifies to configure to use a split horizon with poison reverse.
update - (Optional) Specifies the value of the update timer.
<sec 5-65535> - Enter the update timer value used here. This value must be between 5 and
65535 seconds.
expire - (Optional) Specifies the interval when the update expires.
<sec 1-65535> - Enter the expire value used here. This value must be between 1 and 65535
seconds.
garbage_collection - (Optional) Specifies the value of the garbage-collection timer.
<sec 1-65535> - Enter the garbage-collection timer value used here. This value must be
between 1 and 65535 seconds.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only
Command)
Example
To configure the RIPng method as poison reverse: