D-Link xStack - Chapter 38 File System Management Commands

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
499
Chapter 38 File System
Management
Commands
show storage_media_info {[unit <unit_id> | all]}
md {{unit <unit_id>} <drive_id>} <pathname>
rd {{unit <unit_id>} <drive_id>} <pathname>
cd {<pathname>}
dir {{unit <unit_id>} <drive_id>} {<pathname>}
rename {{unit <unit_id>} <drive_id>} <pathname> <filename>
erase {{unit <unit_id>} <drive_id>} <pathname>
format {unit <unit_id>} <drive_id> {[fat16 | fat32]} {<label_name>}
del {{unit <unit_id>} <drive_id>} <pathname> {recursive}
move {{unit <unit_id>} <drive_id>} <pathname> {{unit <unit_id>} <drive_id>} <pathname>
copy {{unit <unit_id>} <drive_id>} <pathname> {{unit <unit_id>} <drive_id>} <pathname>
change drive {unit <unit_id>} <drive_id>
38-1 show storage_media_info
Description
This command is used to display storage media information.
Format
show storage_media_info {[unit <unit_id> | all]}
Parameters
unit - Specifies the unit ID in the stacking system. If not specified, it refers to the master unit.
<unit_id> - Enter the unit ID value here.
all – Specifies that all the units, in the stacking system’s storage media information will be
displayed.
Restrictions
None.
Example
To display storage media information: