D-Link xStack - Show Ipfdb

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
149
DGS-3620-28SC:admin#clear arptable
Command: clear arptable
Success.
DGS-3620-28SC:admin#
7-7 show ipfdb
Description
This command is used to display the IP address forwarding table on the Switch.
Format
show ipfdb {[ip_address <ipaddr> | interface <ipif_name 12> | port <port>]}
Parameters
ip_address - (Optional) Specifies the IP address of the forwarding table.
<ipaddr> - Enter the IP address to be displayed.
interface - (Optional) Specifies the interface name of the forwarding table.
<ipif_name 12> - Enter the interface name here. This name can be up to 12 characters long.
port - (Optional) Specifies the port to be displayed.
<port> - Enter the port number to be displayed.
Restrictions
None.
Example
To display the IP address forwarding table on the Switch:
DGS-3620-28SC:admin# show ipfdb
Command: show ipfdb
Interface IP Address Port Learned
------------ ---------------- --------- ---------
Total Entries: 0
DGS-3620-28SC:admin#