D-Link xStack Reference Guide

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
994
Example
To enable Q-in-Q:
DGS-3620-28SC:admin#enable qinq
Command: enable qinq
Success.
DGS-3620-28SC:admin#
86-2 disable qinq
Description
This command is used to disable Q-in-Q. When Q-in-Q is disabled, all dynamic learned L2
addresses will be cleared, all dynamic registered VLAN entries will be cleared, and GVRP will be
disabled. To run GVRP on the switch, the administrator should enable GVRP manually.
Format
disable qinq
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To disable Q-in-Q:
DGS-3620-28SC:admin#disable qinq
Command: disable qinq
Success.
DGS-3620-28SC:admin#
86-3 show qinq
Description
This command is used to display the global Q-in-Q status.
Format
show qinq

D-Link xStack Specifications

General

Brand	D-Link
Model	xStack
Category	Switch
Language	English