D-Link xStack - Delete Cfm Linktrace

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
257
DGS-3620-28SC:admin#show cfm linktrace mepname mep1
Command: show cfm linktrace mepname mep1
Trans ID Source MEP Destination
-------- ------------- ------------------
26 mep1 XX-XX-XX-XX-XX-XX
DGS-3620-28SC:admin#
To display a CFM linktrace reply:
DGS-3620-28SC:admin# show cfm linktrace mepname mep trans_id 0
Command: show cfm linktrace mepname mep trans_id 0
Transaction ID: 0
From MEP mep to 00-15-72-20-91-09
Start Time : 2010-12-31 00:51:49
Hop MEPID Ingress MAC Address Egress MAC Address Forwarded Relay Action
--- ----- ------------------- ------------------- --------- ------------
1 - 00-00-00-00-00-00 00-01-02-00-01-14 Yes FDB
2 2 00-15-72-20-91-14 00-15-72-20-91-09 No Hit
DGS-3620-28SC:admin#
16-21 delete cfm linktrace
Description
This command is used to delete the stored link trace response data that have been initiated by the
specified MEP.
Format
delete cfm linktrace {[md [<string 22> | md_index <uint 1-4294967295>] {ma [<string 22> |
ma_index <uint 1-4294967295>] {mepid <int 1-8191>}} | mepname <string 32>]}
Parameters
md - (Optional) Specify the maintenance domain name.
<string 22> - Enter the maintenance domain name. The maximum length is 22 characters.
md_index – Specifies the MD index value used.
<uint 1-4294967295> - Enter the MD index value used here. This value must be between
1 and 4294967295.
ma - (Optional) Specify the maintenance association name.
<string 22> - Enter the maintenance association name. The maximum length is 22
characters.
ma_index – Specifies the MA index value used.
<uint 1-4294967295> - Enter the MA index value used here. This value must be
between 1 and 4294967295.
mepid - (Optional) Specify the MEPID.
<int 1-8191> - Enter the MEP MEPID between 1 and 8191.
mepname - (Optional) Specify the MEP name.
<string 32> - Enter the MEP name. The maximum length is 32 characters.