D-Link xStack - Chapter 79 Policy Route Commands

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
929
Chapter 79 Policy Route
Commands
create policy_route name <policyroute_name 32>
delete policy_route name <policyroute_name 32>
config policy_route name <policyroute_name 32> acl profile_id <value 1-6> access_id <value 1-
256> nexthop <ipaddr> state [enable | disable] {route_preference [default | pbr]}
show policy_route
79-1 create policy_route name
Description
This command is used to create a policy route and define the rule’s name.
Format
create policy_route name <policyroute_name 32>
Parameters
<policyroute_name 32> - The policy route name. The maximum length is 32 characters.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To create a policy route named “danilo”:
DGS-3620-28SC:admin#create policy_route name danilo
Command: create policy_route name danilo
Success.
DGS-3620-28SC:admin#
79-2 delete policy_route name
Description
This command is used to delete a policy route.
Format
delete policy_route name <policyroute_name 32>