D-Link xStack - Show Ipv6 Nd

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
604
disable - When set to disable, the specified prefix will not be used to create an autonomous
address configuration.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the value of the preferred_life_time of prefix option to be 1000 seconds for the prefix
3ffe:501:ffff:100::/64, which is the prefix of the ip1 interface:
DGS-3620-28SC:admin#config ipv6 nd ra prefix_option ipif ip1
3ffe:501:ffff:100::/64 preferred_life_time 1000
Command: config ipv6 nd ra prefix_option ipif ip1 3ffe:501:ffff:100::/64
preferred_life_time 1000
Success.
DGS-3620-28SC:admin#
49-7 show ipv6 nd
Description
This command is used to display IPv6 Neighbor Discover related configuration.
Format
show ipv6 nd {ipif <ipif_name 12>}
Parameters
ipif - (Optional) Specify the interface name.
<ipif_name 12> - Enter the interface name. The maximum length is 12 characters.
Note: If no IP interface is specified, the IPv6 ND related configuration of all interfaces will
be displayed.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To display IPv6 Neighbor Discover related configuration:
DGS-3620-28SC:admin#show ipv6 nd ipif System
Command: show ipv6 nd ipif System
Interface Name : System
Hop Limit : 64