xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
564
Chapter 46
IP Route Filter
Commands
create ip prefix_list <list_name 16>
config ip prefix_list <list_name 16> [[add | delete] {sequence <value 1-65535>}
<network_address> {ge <value 1-32>} {le <value 1-32>} [deny | permit] | [description <desc
80> | clear_description]]
delete ip prefix_list [list_name <list_name 16> | all]
show ip prefix_list {<list_name 16>}
create ip standard access_list <list_name 16>
config ip standard access_list <list_name 16> [add | delete] <network_address> [deny | permit]
delete ip standard access_list [list_name <list_name 16> | all]
show ip standard access_list {<list_name 16>}
clear ip prefix_list counter [<list_name 16> {<network_address>} | all]
create route_map <map_name 16>
config route_map <map_name 16> [[add | delete] sequence <value 1-65535> {[deny | permit]} |
sequence <value 1-65535> [match [add | delete] [as_path <list_name 16> | community_list
<list_name 16> {exact} | ip [next_hop | address] {prefix_list} <list_name 16> | metric <uint 0-
4294967294> | route_type [internal | external | type_1 | type_2] | interface <ipif_name 12> |
route_source <list_name 16>] | set [add | delete] [next_hop [<ipaddr> | peer_address] | metric
<uint 0-4294967294> | local_preference <uint 0-4294967295> | weight <value 0-65535> |
as_path <aspath_list> | community {community_set <community_set 80> | internet |
no_export | no_advertise | local_as} {additive} | origin [egp | igp | incomplete] | dampening
<min 1-45> <value 1-20000> <value 1-20000> <min 1-255> <min 1-45> | metric_type [type_1
delete route_map [map_name <map_name 16> {all_seqence} | all]
show route_map {<map_name 16>}
46-1 create ip prefix_list
Description
This command is used to create an IP prefix list that can be further applied to routes as a filter list.
Format
create ip prefix_list <list_name 16>
Parameters
<list_name 16> - Specifies the name to identify the prefix list.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To creates one IP prefix list named 1:
To Next Page
Loading...
