D-Link xStack - Show Ipif

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
162
11-6 show ipif
Description
This command is used to display IP interface settings.
Format
show ipif {<ipif_name 12>}
Parameters
<ipif_name 12> - (Optional) The name of the interface.
Restrictions
None.
Example
To display IP interface settings:
DGS-3620-28SC:admin#show ipif
Command: show ipif
IP Interface : System
VLAN Name : default
Interface Admin State : Enabled
IPv4 Address : 10.90.90.90/8 (Manual) Primary
Proxy ARP : Disabled (Local : Disabled)
IP Directed Broadcast : Disabled
IPv4 State : Enabled
DHCPv6 Client State : Disabled
DHCPv6 Client PD State : Disabled
IPv6 State : Enabled
IP MTU : 1500
IP Interface : mgmt_ipif
Status : Enabled
IP Address : 192.168.0.1
Subnet Mask : 255.255.255.0
Gateway : 0.0.0.0
Link Status : Link Down
Total Entries: 2
DGS-3620-28SC:admin#
11-7 config out_band_ipif
Description
This command is used to configure the out of band management port settings.