D-Link xStack - Show Scheduling

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
981
wrr - Specifies that each queue will operate based on their weight settings.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the traffic scheduling mechanism for each CoS queue:
DGS-3620-28SC:admin# config scheduling_mechanism strict
Command: config scheduling_mechanism strict
Success.
DGS-3620-28SC:admin#
To configure the traffic scheduling mechanism for the CoS queue on port 1:1:
DGS-3620-28SC:admin# config scheduling_mechanism ports 1:1 strict
Command: config scheduling_mechanism ports 1:1 strict
Success.
DGS-3620-28SC:admin#
85-7 show scheduling
Description
This command is used to display the current traffic scheduling parameters.
Format
show scheduling {<portlist>}
Parameters
<portlist> - (Optional) Specifies the range of ports to be displayed.
Restrictions
None.
Example
To display the traffic scheduling parameters for each CoS queue:
DGS-3620-28SC:admin#show scheduling
Command: show scheduling
QOS Output Scheduling On Port: 1