D-Link xStack - Show Igmp

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
518
<value 1-25> - Enter the last member query interval value here. This value must be between
1 and 25. The default value is 1.
state - (Optional) Specifies the IGMP state on a router interface.
enable - Specifies that the IGMP state will be enabled.
disable - Specifies that the IGMP state will be disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable IGMP version 1 for the IP interface “System”:
DGS-3620-28SC:admin# config igmp ipif System version 1 state enable
Command: config igmp ipif System version 1 state enable
Success.
DGS-3620-28SC:admin#
To configure IGMPv2 for all IP interfaces:
DGS-3620-28SC:admin# config igmp all version 2
Command: config igmp all version 2
Success.
DGS-3620-28SC:admin#
41-2 show igmp
Description
This command is used to display the IGMP configuration.
Format
show igmp {ipif <ipif_name 12>}
Parameters
ipif - (Optional) Specifies the IP interface name used for this configuration.
<ipif_name 12> - Enter the IP interface name used for this configuration here. This name can
be up to 12 characters long.
all - Specifies that all the IP interfaces will be used.
If no parameter is specified, the system will display all IGMP configurations.
Restrictions
None.