xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
507
Parameters
unit - Specifies the unit ID in the stacking system. If not specified, it refers to the master unit.
<unit_id> - Enter the unit ID value here.
<drive_id> - Specifies the drive ID. If not specified, it refers to the current drive.
<pathname> - Enter the file to be copied. If it is specified in the associated form, then it is
related to the current directory.
unit - Specifies the unit ID in the stacking system. If not specified, it refers to the master unit.
<unit_id> - Enter the unit ID value here.
<drive_id> - Specifies the drive ID. If not specified, it refers to the current drive.
<pathname> - Enter the file to copy to. If it is specified in the associated form, then it is
related to the current directory
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To copy a file:
DGS-3620-28SC:admin#copy c:/log.txt c:/log1.txt
Command: copy c:/log.txt c:/log1.txt
Copying............................ Done!
38-12 change drive
Description
This command is used to change the current drive.
Format
change drive {unit <unit_id>} <drive_id>
Parameters
unit - (Optional) Specifies a unit ID if in the stacking system. If not specified, it refers to the
<unit_id> - Enter the unit ID here.
<drive_id> - Specifies the drive ID. The format of drive_id is ‘c:’, or ‘d:’.
Restrictions
None.
Example
To display the storage media’s information:
To Next Page
Loading...
Need help?
General