D-Link xStack - Clear Dhcp Binding; Show Dhcp Binding

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
406
24-19 clear dhcp binding
Description
This command is used to clear a binding entry or all binding entries in a pool or clears all binding
entries in all pools. Note that this command will not clear the dynamic binding entry which matches
a manual binding entry.
Format
clear dhcp binding [<pool_name 12> [<ipaddr> | all] | all]
Parameters
<pool_name 12> - Enter the DHCP pool name to clear.
<ipaddr> - Enter the IP address to clear.
all - Specifies to clear all IP addresses for the specified pool.
all - Specifies to clear all binding entries in all pools
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To clear dynamic binding entries in the pool named “engineering”:
DGS-3620-28SC:admin#clear dhcp binding engineering 10.20.3.4
Command: clear dhcp binding engineering 10.20.3.4
Success.
DGS-3620-28SC:admin#
24-20 show dhcp binding
Description
This command is used to display dynamic binding entries.
Format
show dhcp binding {<pool_name 12>}
Parameters
<pool_name 12> - (Optional) Specify a DHCP pool name.
Restrictions
None.