D-Link xStack - Create Port_Group ID <Value 1-64> Name <Name 16

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
141
DGS-3620-28SC:admin# show egress_flow_meter
Command: show egress_flow_meter
Flow Meter Information:
------------------------
Profile ID : 1 Access ID : 1 Mode : trTcm / color-blind
CIR:1000(Kbps) CBS:2000(Kbyte) PIR:2000(Kbps) PBS:2000(Kbyte)
Actions:
Conform : Permit Replace DSCP : 11 Counter : enable
Exceed : Permit Replace DSCP : 22 Counter : enable
Violate : Drop
Profile ID : 1 Access ID : 1 Mode : srTcm / color-blind
CIR:2500(Kbps) CBS:2000(Kbyte) EBS:3500(Kbyte)
Actions:
Conform : Permit Counter : enable
Exceed : Permit Replace DSCP: 33 Counter : enable
Violate : Drop
Total Entries: 2
DGS-3620-28SC:admin#
6-8 create port_group id
Description
This command is used to create a port group.
Format
create port_group id <value 1-64> name <name 16>
Parameters
id - Specifies the port group ID.
<value 1-64> - Enter the port group ID here. This value must be between 1 and 64.
name - Specifies the port group name.
<name 16> - Enter the port group name here. This name can be up to 16 characters long.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To create a port group: