D-Link xStack - Chapter 107 Traffic Segmentation Commands

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1138
Chapter 107 Traffic
Segmentation
Commands
config traffic_segmentation [<portlist> | all] forward_list [null | all | <portlist>]
show traffic_segmentation {<portlist>}
107-1 config traffic_segmentation
Description
This command is used to configure traffic segmentation.
Format
config traffic_segmentation [<portlist> | all] forward_list [null | all | <portlist>]
Parameters
<portlist> - Enter a range of ports to be configured.
all - Specifies all ports.
forward_list - Specifies a range of port forwarding domains.
null - Specifies the range of the port forwarding domain is null.
all - Specifies all ports.
<portlist> - Enter a range of ports to be configured.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure traffic segmentation:
DGS-3620-28SC:admin#config traffic_segmentation 1-6 forward_list 7-8
Command: config traffic_segmentation 1-6 forward_list 7-8
Success.
DGS-3620-28SC:admin#
107-2 show traffic_segmentation
Description
This command is used to display the traffic segmentation table.