D-Link xStack - Debug Vrrp State

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
336
DGS-3620-28SC:admin# debug vrrp show log state
Command: debug vrrp show log state
VRRP Debug Log State: Disabled
DGS-3620-28SC:admin#
21-36 debug vrrp state
Description
The command is used to enable or disable the VRRP debug state.
Format
debug vrrp state [enable | disable]
Parameters
state - Specifies the state of the VRRP debug state. The default setting is disabled.
enable - Specifies that the VRRP debug state will be enabled.
disable - Specifies that the VRRP debug state will be disabled.
Restrictions
Only Administrator level users can issue this command.
Example
To enable the VRRP debug state:
DGS-3620-28SC:admin# debug vrrp state enable
Command: debug vrrp state enable
Success.
DGS-3620-28SC:admin#
21-37 debug bgp show flag
Description
This command is used for displaying current BGP debugging flags’ setting.
Format
debug bgp show flag
Parameters
None.