D-Link xStack

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
136
DGS-3620-28SC:admin# show egress_access_profile profile_id 1
Command: show egress_access_profile profile_id 1
Egress Access Profile Table
===============================================================================
=
Profile ID: 1 Profile name: 1 Type: Ethernet
Mask on
Source MAC : FF-FF-FF-FF-FF-FF
Available Hardware Entries : 127
-------------------------------------------------------------------------------
-
Rule ID : 1 Port group: -
Match on
VLAN ID : 1
Source MAC : 00-00-00-00-00-01
Action:
Permit
===============================================================================
=
DGS-3620-28SC:admin#
6-5 show current_config egress_access_profile
Description
This command is used to display the egress ACL part of current configuration in user level of
privilege.
The overall current configuration can be displayed by “show config” command which is accessible
in administrator level of privilege.
Format
show current_config egress_access_profile
Parameters
None.
Restrictions
None.
Example
To display current configuration of egress access list table: