D-Link xStack - Chapter 42 IGMP Proxy Commands

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
525
Chapter 42 IGMP Proxy
Commands
enable igmp_proxy
disable igmp_proxy
config igmp_proxy downstream_if [add | delete] vlan [<vlan_name 32> | vlanid <vidlist>]
config igmp_proxy upstream_if {vlan [<vlan_name 32> | vlanid <vlanid 1-4094>] | router_ports
[add | delete] <portlist> | source_ip <ipaddr> | unsolicited_report_interval <sec 0-25>}(1)
show igmp_proxy {group}
42-1 enable igmp_proxy
Description
This command is used to enable the IGMP proxy on the switch.
Format
enable igmp_proxy
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable the IGMP proxy:
DGS-3620-28SC:admin#enable igmp_proxy
Command: enable igmp_proxy
Success.
DGS-3620-28SC:admin#
42-2 disable igmp_proxy
Description
This command is used to disable the IGMP proxy on the switch.
Format
disable igmp_proxy